| Your Lightning Power Battery Cell Gauge is designed to measure the volts of each cell of your lithium pack. It is simple to use. Plug in a 2-3 cell pack through the balancing connector and read the Liquid Crystal Display (LED). The decimal point represents what volt each cell is reading (refer to the label on the gauge). The connector has 2.5 mm pin spacing. If you have balancing connectors that have 2mm pin spacing, use the separately available adapter.
To test packs with 4-12 cell, simple move the gauge over to the next row of pins (see fig. 1). If you plug in the gauge and the LED does not light up, just reverse the connection. You can not hurt the gauge by reversing the polarity.
Remember to remove the gauge from the battery after use to prevent slow discharge of the battery.
|